Construction: AeroCell foam, repairs easily with CA glue
Wing: One-piece
Aileron Control: Dual Servo
Flaps: Optional, hardware included to make flaps operational (two
servos and Y-harness required, see COMMENTS below)
Brushless Motor: 30-35-1000 1000Kv
Electronic Speed Control: 30A
Landing Gear: Fixed, can be easily removed for hand launches and
belly landings, steerable tail wheel, optional prehinged flaps and
retracts
Wheels: Foam, two 2" (51mm) main, 0.83" (21mm) diameter tailwheel
Spinner: Plastic, red and yellow in color, 2.5" (63.5mm) diameter
Servos: Four Tower Hobbies mini size, 14 oz-in (1.0 kg-cm) torque
Propeller: 10x7E composite construction, black in color
Hatch: AeroCell foam, attaches with magnets
Canopy: Clear, painted pilot figure
Warranty: Tower Hobbies guarantees this kit to be free from defects
in both material and workmanship at the date of purchase.
This warranty does not cover any component parts damaged by use or
modification.

Preassembled Wing, Fuselage and Tail Sections, Fixed Landing Gear,
Wheels, Motor, ESC, Propeller, Spinner, Servos and Instruction
Manual - Retracts are not included and can be purchased seperately.

Transmitter and Receiver: At least 4-ch, 6-ch required for optional
retracts & flaps
LiPo Battery: 3S at least 1800mAh
Battery Charger: To match selected battery
Building and field equipment

Length: 34" (864mm)
Wingspan: 40" (1016mm)
Wing Area: 282 sq in (18.2 sq dm)
Weight: 30 - 34oz (850 - 964g)
Wing Loading: 15.3 - 17.2 oz/sq ft (46.7 - 52.5 g/sq dm)
Center of Gravity (CG): 3" (76mm) behind the leading edge of the
wing measured at the fuselage
Control Throws- Low Rate High Rate
Elevator, Up & Down: 1/8" (3mm) 6° 1/4" (6mm) 12°
Rudder, Right to Left: 1/2" (13mm) 14° 11/16" (17mm) 18°
Ailerons, Up & Down: 3/8" (10mm) 18° 1/2" (13mm) 23°
Optional Flaps, Down: 1" (25mm) 24°