Construction: Built-up balsa and light plywood fuselage and tail
assembly, oversize control surfaces to enable 3D maneuvers
Wings: Two-piece balsa sheeted foam with carbon fiber wing tube
Stabilizer: Two-piece with carbon fiber tube
Aileron Control: Dual servo
Rudder Control: Single servo, aft servo mounting position possible
to reduce required tail weight when using a larger glow engine
Covering: MonoKote with authentic Embry Riddle
Aeronautical Institute trim scheme
Cowl: Painted fiberglass
Spinner: Blue plastic 2.5" (64mm) diameter
Landing Gear: Painted fiberglass
Wheels: Main, foam 2.75" (70mm) diameter, Tailwheel 1-1/4" (32mm)
Fuel Tank: Approximately 16oz (480cc)
Engine Mount: Two-piece composite
Cockpit: Pre installed and painted pilot figure
Wheel Pants: Painted fiberglass
Servo Compartment: Plywood reinforced, accessible under canopy,
secures to fuselage with magnets
Building Time: 4-6 hours
Warranty: Great Planes Model Manufacturing Company guarantees this
kit free from defects in both materials and workmanship at
the date of purchase.

.46-.81/EP Great Planes Matt Chapman Eagle 580 Airplane with landing
gear, wheels, decals, pilot figure, instruction manual, engine
mount, fuel tank and spinner

Glow Power: Minimum 4-ch radio w/5 standard servos, 2-stroke .46-
.61 cu in (7.5 - 10cc) OR 4-stroke .52 - .81 cu in (8.5 - 13.5cc)
engine
Electric Power: Minimum 4-ch radio w/4 standard servos, .80 outrunner
brushless motor, 60A brushless ESC, two 11.1V 3200mAh LiPo
batteries, battery charger, motor mount
Building and field

Wingspan: 53" (1350mm)
Wing Area: 645 sq in (41.6 sq dm)
Wing Loading: 21-25 oz/sq ft (64-76 g/sq dm)
Airfoil: Fully symmetrical, low wing placement
Length: 57.5" (1460mm)
Weight: 6-7lb (2720-3180g)
Center of Gravity: 3-3/4" (95mm) back from the leading edge of the
wing at the fuselage side
Control Throws- Low Rate High Rate 3D
Ailerons: 1/4" (6mm) 4° 15/16" (24mm) 14° 1-3/4" (44mm) 26°
Elevator: 3/8" (10mm) 5° 11/16" (17mm) 10° 2-3/8" (60mm) 35°
Rudder: 1-3/4" (44mm) 16° 2-1/4" (57mm) 20° 3" (76mm) 28°