Construction: Balsa and ply
Wings: Two-piece with NACA airfoils, two aluminum joiner tubes
Aileron Control: Dual servo
Covering: High quality heat shrink covering
Cowl: Fiberglass
Motor Mount: Plywood
Engine Mount: Two piece composite plastic
Landing Gear: Retractable with CNC machined struts, two 3" (76mm)
foam main wheels, 1" (25.4mm) rubber wheel
Fuel Tank: 12oz (360cc) approximate

ARF F4U C-orsair with Landing Gear, Wheels, Wheel Pants, Fuel Tank,
Cowl, and Instruction Manual

Radio: 6-channel minimum
Servo: 5 standard,: 2-aileron; 1-elevator; 1-rudder; 1-throttle (if
using glow engine)
Servo Extensions: Two 12-18" for ailerons, length depends on where
receiver is located
Retract Servos: Two mechanical retract servos such as the Futaba
S3170G
Receiver Battery: 4.8-6V / 800-1200mAh NiMH

For electric power;
Brushless Motor: Rimfire .46-.55
ESC: 50-80A
LiPo Battery: 6S, at least 4000mAh
Battery Charger: Compatible with selected battery
LiPo charging bag, propeller, field equipment
Glow Power;
Engine: .46-.55 cu in 2-stroke, OR .52 cu in 4-stroke
Propeller: For selected engine
Glow fuel, glow starter, field equipment

Wingspan: 58.5" (1485mm)
Length: 44.5" (1127mm)
Flying Weight: 106-116oz (3000-3300g)
Wing Area: 592 sq in (38.2 sq dm)
Wing Loading: 24.5 oz/sq ft (75 g/sq dm)
Wing Type:
Center of Gravity: 3.5" (90mm) back from the leading
edge of the wing measured at the fuselage
Control Throws- Low High
Ailerons: 0.39" (10mm) 10% expo 0.47" (12mm) 10% expo
Elevator: 0.31" (8mm) 12% expo 0.39" (10mm) 12% expo
Rudder: 0.98" (25mm) 15% expo 1.57" (40mm) 15% expo