Construction: Laser cut balsa and ply
Wing: Two-piece bolt-on
Aileron Control: Dual servo
Canopy: Molded plastic red in color with clear windshield area
Covering: High quality heat shrink covering
Cowl: Fibrglass, painted to match color scheme
Landing Gear: Aluminum prebent main gear, spring wire steerable tail
gear
Wheel Pants:
Spinner: Red plastic 2.7" (70mm) diameter
Fuel Tank: --oz (--cc)
Engine Mount: Two piece composite
Motor Mount: Plywood

Stinson Reliant Airplane with Landing Gear, Wheels, Wheel Pants,
Spinner, Fuel Tank, Motor Mount, Engine Mount and Instructions

Radio: At least 6-channel
Servo: 7 standard: 2-aileron, 2-flap, 1-elevator, 1-rudder,
1-throttle
Receiver Battery: 4.8-6V, 800-1200mAh
Glow Power;
Engine: .61-.91 cu in 2-stroke, or .91 - 1.08 4-stroke, or
15cc gasoline powered
Propeller: Depending on selected engine
Electric Power;
Motor: RIMFIRE .80
Lipo Battery: 6-10S, at least 4000mAh with LiPo charging bag
ESC: 60-100A

Building and field equipment

Wingspan: 67.7" (1720mm)
Length: 52.6" (1338mm)
Flying Weight: 9.7-10.5lbs (4400-4800g)
Wing Area: 653 sq in (42.2 sq dm)
Wing Loading: 29.49 oz sq dm (90g/sq dm)
Airfoil: Clark Y
Servo Mount: 0.83 x 1.6" (21mm x 42mm)
Center of Gravity (CG): 2.5-2.7" (65-70mm) back from the leading edge
of the wing at the fuselage
Control Throws: Low High
Ailerons: 11mm up/down 10% expo 13mm up/down 10% expo
Elevator: 11mm up/down 12% expo 13mm up/down 12% expo
Rudder: 20mm right/left 15% expo 30mm right/left 15% expo
Flap: 15-20mm down